RF 96 WPHM SW922 LBT

Wireless position switch
Material number: on request
  • Thermoplastic enclosure
  • Mounting details to EN 50047
  • Output signal can be individually configurated at the receiver
  • sWave® wireless technology
  • No wiring and pipe laying required
  • Power supply by Lithium battery (replaceable)
  • Easy programming of receiver
  • LBT - Listen before Talk Software
  • Actuator: Parallel metal roller lever with collar WPHM
  • Actuating speed max. 0.5 m/s with an actuating angle of 30°
  • Watertight collar for protection against penetration of dirt
  • Wear-resistant plastic roller
  • Actuator can be repositioned by 4 x 90°
  • Actuation parallel to switch from below
Note
  • With metal roller available on request
Contact

Technical data

Applied standards EN 60947-5-1, EN 61000-6-2, EN 61000-6-3, EN 61000-4-2, EN 301 489-1, EN 301 489-3, EN 300 220-1, EN 300 220-2
Enclosure thermoplastic, glass-fibre reinforced, impact resistant, self-extinguishing UL 94 V-0
Cover thermoplastic, glass-fibre reinforced, impact resistant, self-extinguishing UL 94 V-0
Tightening torque M4 enclosure mounting screw: max 1.2 Nm
M2.5 cover screws: approx. 0.45 Nm
Degree of protection IP 67 to IEC/EN 60529
Protocol sWave®
Frequency 916.5 MHz (Japan)
Transmission power < 1 mW
Data rate 66 kbps
Channel bandwidth 520 kHz
Voltage supply Lithium battery SL-2770 (replaceable)
System Li/SOCl2
Nominal voltage 3.6 V
Nominal capacity 8.5 Ah
Battery life depending on the switching frequency
1 s approx. 780 days,
10 s approx. 1300 days,
100 s approx. 1400 days
Ambient temperature –20 °C … +65 °C
Operation cycles max. 1440 telegrams with repetitions/h
Standby current 1.5 µA
Wireless range max. 150 m outside,
max. 20 m inside
Mechanical life > 1 million operations
Actuating time min. 80 ms
Note Status signal adjustable via jumper, no, 10 s, 100 s, 1000 s, 10000 s
Delivery state: jumper position without status signal
Transmission of battery voltage and switching condition
Wireless approvals Japan: ARIB STD-T108: 204-610002

Actuating angle

α - Actuating angle from bottom of switch axis as shown in picture


Accessories

Wireless receiver
RF Rx SW922-2W-RS232 24 VAC/DC
  • sWave® wireless technology
  • 2 potential-free relay outputs
  • 2 change-over contacts, max. 6 A
  • RS 232 interface
  • Transmitter/receiver assignment by teaching mode
  • LEDs for indication of switching state
  • SMA plug-in connector for external antenna
Wireless receiver
RF Rx SW922-4S 24VDC - SET
  • sWave® wireless technology
  • 4 potential-free relay outputs
  • 4 NO contacts, max. 3 A
  • Transmitter/receiver assignment by teaching mode
  • LEDs for indication of switching state
  • SMA plug-in connector for external antenna
Wireless receiver
RF Rx SW922-4S 24VDC Power-down-function
  • sWave® wireless technology
  • 4 potential-free relay outputs
  • 4 NO contacts, max. 3 A
  • Transmitter/receiver assignment by teaching mode
  • LEDs for indication of switching state
  • SMA plug-in connector for external antenna
  • Power-down-function (saves the last signal status from the relay output, if the power supply of the receiver box is interrupted)
Wireless receiver
RF Rx SW922-TCP/IP V2
  • sWave® wireless technology
  • Communication via UDP or TCP/IP (Server or Client - Mode)
  • Webserver based Setup
  • Transmitter/receiver assignment by teaching mode
  • LEDs for indication of operating state
  • SMA plug-in connector for external antenna
Wireless receiver / repeater
RF RxT SW922-USB
  • Different operating modes
  • USB-Standard Receiver Mode
  • USB Gateway Mode
  • Sniffer Mode
  • Repeater (1-Level and 2-Level Repeater Mode)
  • Virtual COM Port driver for Microsoft Windows, Linux, Apple Mac
RF magnet antenna SMA plug-in connector straight 2.5 m
  • RF magnet antenna with straight SMA plug-in connector without ferrite core
  • Suitable for SW868, SW922 and EN868
  • Cable length 2.5 m
RF magnet antenna 5dBi SMA plug-in connector straight 1.5 m
  • RF magnet antenna with straight SMA plug-in connector without ferrite core
  • Suitable for SW868, SW922 and EN868
  • Cable length 1.5 m
RF magnet antenna 2dBi SMA plug-in connector straight 2 m
  • RF magnet antenna with straight SMA plug-in connector without ferrite core
  • Suitable for SW868, SW922 and EN868
  • Cable length 2 m
RF SMA antenna socket 0.5 m
  • Suitable for antennae with SMA plug-in connector
  • RF SMA antenna socket with straight SMA plug-in connector
  • Cable length 0.5 m
RF SMA antenna extension 3 m
  • Plug on left side: straight SMA plug
  • Socket on right side: straight SMA socket
RF SMA antenna extension 5 m
  • Plug on left side: straight SMA plug
  • Socket on right side: straight SMA socket