RF 95 WHM ULR SW868

Wireless position switch
Material number: 1214704
(Material number old: 95914005)
  • Thermoplastic enclosure
  • Design to EN 50047
  • sWave® wireless technology
  • No power supply, no wiring and pipe laying required
  • Easy programming of receiver
  • Output signal can be individually configurated at the receiver
  • Actuator: Metal roller lever with collar WHM
  • Actuating speed max. 0.5 m/s with a vertical actuating angle
    of α = 40° and β = 25°
  • Watertight collar for protection against penetration of dirt
  • Wear-resistant plastic roller
  • Actuator can be repositioned by 4 x 90°
Note
  • With metal roller available on request
Contact

Technical data

Applied standards EN 60947-5-1, EN 61000-6-2, EN 61000-6-3, EN 61000-4-2, EN 301 489-1, EN 301 489-3, EN 300 220-1, EN 300 220-2
Enclosure thermoplastic, glass-fibre reinforced, impact resistant, self-extinguishing UL 94 V-0
Cover thermoplastic, glass-fibre reinforced, impact resistant, self-extinguishing UL 94 V-0
Tightening torque enclosure mounting screws: 1.2 … 1.3 Nm
cover screws: 0.5 … 0.6 Nm
Degree of protection IP 67 to IEC/EN 60529
Protocol sWave®
Frequency 868.3 MHz (Europe)
Transmission power < 25 mW
Data rate 66 kbps
Channel bandwidth 480 kHz
Voltage supply Electrodynamic energy generator
Ambient temperature –20 °C … +65 °C
Operation cycles approx. 12000 telegrams with repetitions/h
Wireless range max. 700 m outside,
max. 50 m inside
Mechanical life > 1 million operations
Actuating time min. 80 ms
Note no status signal available
Wireless approvals Europe: RED 2014/53/EU
Weight 82 g

Switching diagram

Actuating angles

α - Actuating angle from right of switch axis
β - Actuating angle from left of switch axis as shown in picture


Accessories

Wireless receiver
RF Rx SW868-TCP/IP V2
  • sWave® wireless technology
  • Communication via UDP or TCP/IP (Server or Client - Mode)
  • Webserver based Setup
  • Transmitter/receiver assignment by teaching mode
  • LEDs for indication of operating state
  • SMA plug-in connector for external antenna
Wireless receiver / repeater
RF RxT SW868-USB
  • Different operating modes
  • USB-Standard Receiver Mode
  • USB Gateway Mode
  • Sniffer Mode
  • Repeater (1-Level and 2-Level Repeater Mode)
  • Virtual COM Port driver for Microsoft Windows, Linux, Apple Mac
Wireless receiver
RF Rx SW868-1W 24 VAC/DC
  • sWave® wireless technology
  • 1 potential-free relay output
  • 1 change-over contact, max. 6 A
  • Transmitter/receiver assignment by teaching mode
  • LEDs for indication of switching state
  • SMA plug-in connector for external antenna
Wireless receiver
RF Rx SW868-2W-RS232 24 VAC/DC
  • sWave® wireless technology
  • 2 potential-free relay outputs
  • 2 change-over contacts, max. 6 A
  • RS 232 interface
  • Transmitter/receiver assignment by teaching mode
  • LEDs for indication of switching state
  • SMA plug-in connector for external antenna
Wireless receiver
RF Rx SW868-4W 24 VAC/DC
  • sWave® wireless technology
  • 4 potential-free relay outputs
  • 4 change-over contacts
  • Transmitter/receiver assignment by teaching mode
  • LEDs for indication of switching state
  • SMA plug-in connector for external antenna
Wireless receiver
RF Rx SW868-4S 24VDC - SET
  • sWave® wireless technology
  • 4 potential-free relay outputs
  • 4 NO contacts, max. 3 A
  • Transmitter/receiver assignment by teaching mode
  • LEDs for indication of switching state
  • SMA plug-in connector for external antenna
Wireless receiver
RF Rx SW868-4S 24VDC Power-down-function
  • sWave® wireless technology
  • 4 potential-free relay outputs
  • 4 NO contacts, max. 3 A
  • Transmitter/receiver assignment by teaching mode
  • LEDs for indication of switching state
  • SMA plug-in connector for external antenna
  • Power-down-function (saves the last signal status from the relay output, if the power supply of the receiver box is interrupted)
Wireless repeater
RF RxT SW868-1K
  • sWave® wireless technology
  • LEDs for indication of operating state
  • 1-level repeater: for the signal gain between transmitter and receiver
  • SMA plug-in connector for external antenna
Wireless repeater
RF RxT SW868-2K
  • sWave® wireless technology
  • LEDs for indication of operating state
  • 1-level repeater: for the signal gain between transmitter and receiver
  • 2-level repeater: for the signal gain of one 1-level repeater
  • SMA plug-in connector for external antenna
Power supply 24V DC
  • Push-in terminals
RF magnet antenna 5dBi SMA plug-in connector straight 1.5 m
  • RF magnet antenna with straight SMA plug-in connector without ferrite core
  • Suitable for SW868, SW922 and EN868
  • Cable length 1.5 m
RF magnet antenna 2dBi SMA plug-in connector straight 2 m
  • RF magnet antenna with straight SMA plug-in connector without ferrite core
  • Suitable for SW868, SW922 and EN868
  • Cable length 2 m
RF SMA antenna socket 0.5 m
  • Suitable for antennae with SMA plug-in connector
  • RF SMA antenna socket with straight SMA plug-in connector
  • Cable length 0.5 m
RF Magnet antenna 5dBi TNC plug-in connector IP 65 3.6 m
  • RF magnet antenna with straight TNC plug-in connector
  • Suitable for SW868 and EN868
  • Cable length 3.6 m
RF SMA antenna socket 0.5 m with TNC plug-in connector IP 65
  • Suitable for RF antenna 1275629
  • RF SMA antenna socket with straight TNC plug-in connector
  • Cable length 0.5 m
RF SMA antenna extension 3 m
  • Plug on left side: straight SMA plug
  • Socket on right side: straight SMA socket
RF SMA antenna extension 5 m
  • Plug on left side: straight SMA plug
  • Socket on right side: straight SMA socket
Field strength testing tool swView 868 MHz
  • Only suitable for sWave® 868 MHz wireless technology
  • Mobile field strength indicator for link range testing
  • To measure and indicate the electrical field strength
  • The batteries are included in delivery
  • Several functions can be selected: Scan-Mode, Repeat-Mode, Rescan-Mode, Radio-Link